The nano F3 range of mid pressure compressed air and gas filters consists of nine models in three different housing designs. Manufactured from machined and die cast aluminum and polyester powder coated for optimum corrosion protection, the nano F3 mid pressure compressed air and gas filters are designed for the unique demands of high pressure applications. These filters incorporate an innovative push-fit element design with dual o-ring seals to ensure optimum sealing and mechanical strength. Choose from five different filter elements including 25, 5, 1 and 0.01 micron coalescing and/or dust filtration, and activated carbon oil vapor removal. The custom engineered filter media is designed to provide low air velocity preventing oil carry over for high efficiency filtration with minimal pressure drop.
• Manufactured in an ISO 9001 approved facility and tested in accordance with ISO 8573-1:2010.
• differential pressure indicator not included
• install with air flow from inside to outside for coalescing and from outside to inside for dry dust filtration
*Scroll to the right on mobile to see entire chart
Model
replacement element
Inlet & Outlet NPT
rated flow1
scfm
Nm3/h
N50A 0094 (grade)
E50HP 0094 (grade)
¼"
94
160
N50A 0147 (grade)
E50HP 0147 (grade)
⅜"
147
250
N50A 0265 (grade)
E50HP 0265 (grade)
½"
265
450
N50A 0324 (grade)
E50HP 0324 (grade)
¾"
324
550
N50A 0492 (grade)
E50HP 0492 (grade)
1"
492
835
N50A 0736 (grade)
E50HP 0736 (grade)
1½"
736
1250
N50A 1015 (grade)
E50HP 1132 (grade)
1½"
1015
1725
N50A 1132 (grade)
E50HP 1132 (grade)
2"
1132
1925
N50A 1882 (grade)
E50HP 1882 (grade)
2"
1882
3200
(1) at 725 psig. For all other pressures, refer to the pressure correction factor table
*Scroll to the right on mobile to see entire chart
Specifications
design operating pressure range
0 to 725 psig
condensate drain (included)
manual ball valve
filter housing material
machined & die cast aluminum
*Scroll to the right on mobile to see entire chart
element performance
M25
M5
M1
M01
AC2
particle removal (microns)
25
5
1
0.01
-
max oil carry over at 68°F (ppm or mg/m3)
10
5
0.1
0.01
0.003
recommended operating temp range (°F)
35 - 212
35 - 212
35 - 212
35 - 212
35 - 77
design operating temperature range (°F)
35 - 248
35 - 248
35 - 248
35 - 248
35 - 122
(2) Activated carbon filters must always be installed immediately downstream of a M01 coalescing filter.
They will not remove carbon monoxide (CO) or carbon dioxide (C02) and are not suitable for breathing
air applications. The life of the element decreases as the inlet temperature increases. They are not
recommended for temperatures above 77°F. As a maximum, activated carbon elements should be replaced every 1000 hours or 6 months, whichever is shorter.
AirDryerTech.com is owned and operated by mdi, Manufacturers Distributor, Inc. mdi is an Authorized Pneumatech and Nano Distributor. Click Here to view the mdi Line Sheet.
Click Here to view the mdi Line Sheet.